To run the Fraverb board in mono do I just use the inR and the outR or do I have to tie the left and rights to gether??? :)
I think Spin recommends tying the inputs together, and letting the unused output float (leave it unconnected).
Thanks! I'll give it a try. I'll be gone for a week so I won't report on it till after I get back.
You were right! I found this on Spins site:
Posted: Thu May 06, 2010 11:01 am Post subject:
--------------------------------------------------------------------------------
Tie the input pins together so the unused input is driven. Let the unused output just float, in code I would write the same value to it as the used output so it was driven internally but not connect anything to the pin.
_________________
Frank Thomson
OCT Distribution