AMZ FX ANALOG ALCHEMY GEOFX MEF ROG DIY WIKI

DOD 250 yjm spec

Started by Kipper4, February 01, 2013, 08:52:52 PM

Previous topic - Next topic
Print
Go Down Pages 1 2
User actions

PRR

#20
February 06, 2013, 01:23:37 AM
Quote from: Tony Forestiere on February 05, 2013, 07:58:09 PM...voltages on most dual op-amps in MOST circuits want to be:
pin1 - 1/2 V+
pin2 - 1/2 V+
pin3 - 1/2 V+
Pin4 - 0V - (continuity to GND) A lot of folks figure if they are reading 0 volts, they are good without checking true continuity to GND.
pin5 - 1/2 V+
pin6 - 1/2 V+
pin7 - 1/2 V+
pin8 V+ - (supply voltage)

This should be pinned to a Debugging thread.
  • SUPPORTER

Kipper4

#21
February 06, 2013, 04:10:17 PM
It should be pinned on page 1
easy to remember info that really helps thats what us newbies need
thanks again
Ma throats as dry as an overcooked kipper.


Smoke me a Kipper. I'll be back for breakfast.

Grey Paper.
http://www.aronnelson.com/DIYFiles/up/
Print
Go Up Pages 1 2
User actions