LHX2 amp sim - draft PCB layout

[mikeb]

It's a pdb (v6) document.....
http://prophecysound.com/diyroot/DIYeffects/LHXampsim/layoutv1_0.pdf

Please check against the original schematic - I copied the schematic into protel, and the layout matches the schematic fine, just perhaps I made some mistakes .... ?

When checked by someone else I'll repackage so can be used for PCB production.

Mike

PS I've intentionally left one small mistake in there to see if people actually look at this thing ..... .... a labelling error ....

[mikeb]

bump!

[Marcos - Munky]

Cool layout, Mike. Where is the original schematic to compare to the layout?

[mikeb]

Here's the original thread:
http://www.diystompboxes.com/sboxforum/viewtopic.php?t=24201

Mike

[Marcos - Munky]

I found it!!!!!!!!!!!
Can I post the error here? I will PM you the error, then the users will need to check the layout to discover it.

[Branimir]

thanks mike!!!!

i'm rather busy this moment, i'll check it out tommorow and try to build it on tuesday...

[mikeb]

Yep, Marcos got it - there's no label near a pad for 'output level wiper', only one for ground!

I'll upload a corrected version later on today with a separate parts layout and PCB layout.

Mike