aron what is the mounting hole diameter for your 3PDT switch

[bazzwazzle]

thanks in advance.

[mikeb]

12mm or 1/2"

Mike

[petemoore]

yupp 1/2...I was drillin' yesterday for one.

[bazzwazzle]

1/2" diameter? ok thanks.

[aron]

Thanks guys! Yeah, I use that unibit for everything so I don't even measure or anything. Just keep drilling till it fits.

[Fret Wire]

3PDT shaft dia. = .460-.463
             15/32 = .469
            12mm = .472
                1/2 = .500

I usually use 15/32, nice and tight. 12mm is just about perfect. Nice and tight, and there's room for bit wear. 1/2 will never miss.

The Unibit solves all the math.

[bazzwazzle]

eh, i don't have a unibit and short on money. you lucky people with jobs. I need a job. i'm too young