Author Topic: center tap pot  (Read 1575 times)

0 Members and 1 Guest are viewing this topic.

birt

center tap pot
« on: October 09, 2007, 01:15:55 AM »
these seem very hard to find so i was wondering if there is any way to get around this...

i was trying to get what resembles a CT pot by connecting various lugs of a stereo pot but it didn't work out. is there any way to make a pseudo CT pot?
http://www.last.fm/user/birt/
visit http://www.effectsdatabase.com for info on (allmost) every effect in the world!

petemoore

Re: center tap pot
« Reply #1 on: October 09, 2007, 01:23:25 AM »
  Center 'detent' maybe? Has a notch to find the middle position?
  Center tap is a term used for tranformers mostly.
Convention creates following, following creates convention.

GREEN FUZ


darron

« Last Edit: October 09, 2007, 01:50:49 AM by darron »
Blood, Sweat & Flux. Pedals made with lasers and real wires!

birt

Re: center tap pot
« Reply #4 on: October 09, 2007, 04:58:50 AM »
i didn't find that topic, tnx! not easy to do tough. especially since i have to replace at least 2 (shafts broken off completely so i HAVE to replace them)

it's for the super twin reverb mentioned there.
http://www.last.fm/user/birt/
visit http://www.effectsdatabase.com for info on (allmost) every effect in the world!

darron

Re: center tap pot
« Reply #5 on: October 09, 2007, 12:10:32 PM »
good thing you are into diy (:
Blood, Sweat & Flux. Pedals made with lasers and real wires!