Source for a Pulsar Tremolo PCB?

[fiveightandten]

Apologies if this is common knowledge around here, but after searching here and googling around online, I can't find any vendors that currently make a PCB for a Pulsar Tremolo clone.

I've seen the PDF documents with the PCB and layout, but I don't have any experience making my own and don't really care to considering the prices boards normally sell for. I'm just looking for something with a decent layout that will not tick. I don't have an enclosure yet, so size isn't an issue.

Anyone know where I can find one? Thanks in advance.

-Nick

[Dragonfly]

PROJECT - http://www.tonepad.com/project.asp?id=14

I checked Tonepad for a PCB, but I didn't see one. Contact forum member "John Lyons" about making one for you. (His screen name may also be "Basic Audio")

[newfish]

.

PROJECT - http://www.tonepad.com/project.asp?id=14

I checked Tonepad for a PCB, but I didn't see one. Contact forum member "John Lyons" about making one for you. (His screen name may also be "Basic Audio")

(beaten to the punch)

Tonepad sells a Pulsar board.

http://www.tonepad.com/project.asp?id=14

Good quality boards with clearly laid-out .pdf supporting documents.

Other suppliers are undoubtedly available, but Francisco would be my 'go-to' for a clone board I wasn't going to etch.

Hope this helps.

[Dragonfly]

Tonepad sells a Pulsar board.

http://www.tonepad.com/project.asp?id=14

If they do, it isn't listed on their ordering page -

http://www.tonepad.com/tonepadshoppingcart.html

[fiveightandten]

PROJECT - http://www.tonepad.com/project.asp?id=14

I checked Tonepad for a PCB, but I didn't see one. Contact forum member "John Lyons" about making one for you. (His screen name may also be "Basic Audio")

Thanks for the suggestion! I'll get in touch with John.

(beaten to the punch)

Tonepad sells a Pulsar board.

http://www.tonepad.com/project.asp?id=14

Good quality boards with clearly laid-out .pdf supporting documents.

Other suppliers are undoubtedly available, but Francisco would be my 'go-to' for a clone board I wasn't going to etch.

Hope this helps.

Thanks for the reply, but I checked tonepad and it says the board is not available. Do you think it's worth contacting them via email and disregarding the note on the website?

-Nick

[fiveightandten]

Just wanted to bump this up and say thanks again. I got in touch with John Lyons, and he'll be making the PCB for me. Thanks again for the referral.

-Nick

[Dragonfly]

Just wanted to bump this up and say thanks again. I got in touch with John Lyons, and he'll be making the PCB for me. Thanks again for the referral.

-Nick

Glad I could help. John does truly top notch work....you'll be VERY happy !