Author Topic: Thunder Up - Distortion  (Read 1702 times)

0 Members and 1 Guest are viewing this topic.

WGTP

Stomping Out Sparks & Flames

roseblood11

Re: Thunder Up - Distortion
« Reply #1 on: June 01, 2012, 03:59:12 AM »
looks good!
but the transistors and the diode aren't labeled in your schematic.

WGTP

Re: Thunder Up - Distortion
« Reply #2 on: June 01, 2012, 12:58:09 PM »
There such standard stuff, I totally forgot.  Mosfet is BS170, Jfet's J201 and diode 1N4818.  Sorry.  ;)
Stomping Out Sparks & Flames

J0K3RX

Doesn't matter what you did to get it... If it sounds good, then it is good!

WGTP

Re: Thunder Up - Distortion
« Reply #4 on: June 02, 2012, 02:26:54 PM »
With a 2.2k resistor at the source of the last stage it is smooth and compressed.  With the diode, it's hot and nasty.   A 10k trim pot would work well there.  I should probably change the resistor in the tonestack from 100k to 47k or 22k (another trim pot).   :icon_twisted:
« Last Edit: June 02, 2012, 02:42:04 PM by WGTP »
Stomping Out Sparks & Flames