The grille was made from alu tube and chrome tape
(http://]http://www.mikehoughton.co.uk%5CBlagstar%5Cgrille.jpg)
Great mod! O/P level goes right up to 11
(http://]http://www.mikehoughton.co.uk%5CBlagstar%5Clevel.jpg)
I made two boards so that each could be tested on its own. This is the low volts brd
(http://]http://www.mikehoughton.co.uk%5CBlagstar%5Ctopbd.jpg)
This is the valve stuff that hurts if you touch the wrong bit
(http://]http://www.mikehoughton.co.uk%5CBlagstar%5Cvalveamp.jpg)
Valve bd and chassis fitted
(http://]http://www.mikehoughton.co.uk%5CBlagstar%5Cvalvefitted.jpg)
I only ever use wires on the copm side for power. This is the copper side
(except the valve bit which is all on top)
(http://]http://www.mikehoughton.co.uk%5CBlagstar%5Ctracks.jpg)
General views...
(http://]http://www.mikehoughton.co.uk%5CBlagstar%5Ctop2.jpg)
(http://]http://www.mikehoughton.co.uk%5CBlagstar%5Csubassy.jpg)
(http://]http://www.mikehoughton.co.uk%5CBlagstar%5Ctop1.jpg)
This code was used: [img height= .....
img height=400]http://]http://www.mikehoughton.co.uk\Blagstar\top1.jpg[/img]//
This code was used: [img height= .....
img height=400 ]http://www.mikehoughton.co.uk\Blagstar\top1.jpg[/img]
Nope. Don't work
Pics not showing up.
(http://www.mikehoughton.co.uk/blagstar/top1.jpg)
Code used :
(open bracket)img height=450]http://www.mikehoughton.co.uk/blagstar/top1.jpg[/img(closebracket)
your code (after php-ing) shows like this in the source.
<img src="http://]http://www.mikehoughton.co.uk\Blagstar\top2.jpg" alt="" height="400" border="0" />
you need only one http:// for tikkety-boo-ing images, so it needs to look like this when you type it in .....
[edit :] oops. some bad slashes removed ....
[edit :] well, there you go. enter the addy w/ backslashes, and my browser reversed them for me.
Quote from: duck_arse on September 11, 2014, 12:41:51 PM
[img height=400]http://www.mikehoughton.co.uk\Blagstar\top2.jpg[/img]
Look out though, the link will not work with the backslashes "\"