Hi, does anyone have an easy to follow diagram for this footswitch? I want to have LEDs.
I found this one, but not sure if it's the best way of doing it?
(http://i207.photobucket.com/albums/bb89/SomeoneYouKnew/schematics/FootswitchLEDs.png)
Assuming the current two foot switches are SPDT (single pole double throw) you'll have to swap them out for two DPDT (double pole double throw) as the schematic implies - to have the relay space for the LEDs.
The only note I can make is I would put the resistor from the + voltage to the middle lug leaving the bottom unconnected. Though I feel this is more of a preference.
Look up how these relays function to understand best. It's very simple.
That schematic will suffice. Try using 200 ohm resistors or whatever your preference may be.
I have an interesting variation on this topic. I have two Fender Princeton Reverb Reissues and want to simultaneously control the vib/rev on each of them. Example: two switches (vib + rev) and two jacks (one to each amp). Clicking the "vib" switch turns on/off vibrato for both amps, similar for reverb.
LEDs would be nice, but not necessary.
Could someone help me out with parts/schematic for this?