the schematic asks for a 600:600 transformer ie OEP1200 transformer
however from building some aby isolation pedals i have some
42TM018-RC
left over
http://www.mouser.com/ds/2/449/XC-600134-205894.pdf
these are 550:500
they are used for the same purpose to use multiamp setups eliminate ground loop hum,
these should be ok in the Lovetone clone?
The little wax-jobs are rated 300Hz bottom. Two octaves off a guitar's bass.
They *may* do considerable better, but it depends on the circuit.
If the wax-irons are in your hand, try them. Should not smoke. May be full guitar bass, or may be bass shy, depending on the schematic you did not show/link.
https://www.dropbox.com/sh/3v4twi2sbs0l5p7/1Ep9NbRE2T?preview=Lovetone+V1+Clone+Build+Docs.pdf
(http://i999.photobucket.com/albums/af111/njkmonty/ScreenHunter_18%20Apr.%2008%2013.43_zpslsvhgxnh.jpg)
here is the OEP 1200 1:1 600 Ohm low profile line isolation transformers data sheet link
http://www.farnell.com/datasheets/13721.pdf (http://www.farnell.com/datasheets/13721.pdf)
> here is the OEP 1200 1:1 600 Ohm low profile line isolation transformers data sheet link
That's quite comparable to what you have in hand.
Try it.
ok goodo!
this is what i originally bought them for
http://www.geofex.com/FX_images/TransformerSplitter.pdf
just wish to confirm that the 42TM018-RC worked great on my build, just had to make sure they were connected correctly as the connections were a little different to ones specified.
Small Bear sells them too!