Text only | Text with Images

DIYstompboxes.com

DIY Stompboxes => Building your own stompbox => Topic started by: merlyner on January 15, 2004, 05:08:49 PM

Title: Neovibe question please help
Post by: merlyner on January 15, 2004, 05:08:49 PM
Hi, im building a neovibe and i was taking a look at the PCB board layout last night : http://www.generalguitargadgets.com/v2/diagrams/neovibe.pdf
and I can't find out how the thing gets power.  Obviously not from a 9volt and there are two wires K and J that say 14vac to 20 vac or 18VDC to 24VDC.  Do I just wire these two up to a DC power jack and then use an AC adapter that fits the requirements? thanks for the help.
Title: Neovibe question please help
Post by: merlyner on January 15, 2004, 05:36:45 PM
bump
Title: Neovibe question please help
Post by: R.G. on January 15, 2004, 08:09:21 PM
The NeoVibe takes a supply of 18 to 24Vdc internally, and makes its own DC if fed AC. The simplest thing to do is to feed it 18vac to 24vac from a suitable wall wart.

The commonest mistake that everyone makes is that they use a jack that allows one of the incoming power lines to contact the case. In building the NeoVibe you MUST NOT allow either incoming power line, AC or DC, to connect to the case. Doing so will keep the pedal from working. Use an ohmmeter to verify that the jack you use does not allow this to happen.
Title: Neovibe question please help
Post by: merlyner on January 15, 2004, 10:09:02 PM
how would a keep it from connecting to the case?
Title: Neovibe question please help
Post by: JT on January 15, 2004, 11:50:15 PM
Plastic Jack  :wink:
Text only | Text with Images