Had problems finishing my Easyvibe a few days ago.
Today I found a mistake on the board and fixed it. (Missing connenction while drawing it in Illustrator) I used LDR's with light resistance 75 - 300 at 1000 lx and dark resistance at 10 M after 10 minutes and only 1 Euro each.
Now it works and sounds fantastic!!!
Great Pedal!!! Great Project!!!
Any ideas on mods out there!
Greetings from Germany,
Jan
Congrads!
I finished my EasyVibe a few weeks ago - about to box it up.. it's a really great sounding circuit.
if you hook up your status LED to ground (through your switch) and take the + feed from right after the trimpot, it'll pulse in time with the LFO.
"-)
Way to hang in there Jan! Satisfying! Do ya hear some Jimi comin outta that thang?
Hi Jan!
Where in Germany did you order your LDRs? I´ve tried to build the Easyvibe two times now, it did never work :cry:
Schöne Grüße,
Klaus
I'm looking forward to build it soon (lot's of pedals to build :wink: )
Therefor I bought a broken Crybaby (which wasn't broken) I will use as enclosure to get a little Univibe feel...
Anyway...nice to see some other german guys around here (Ich gehe zur Uni in Karlsruhe).
Good morning everyone,
yeah, there comes a little Jimi out of it!
Thanks for the tip with the pulsing LED. I will try that.
Hallo Klaus,
I've bought them at Conrad
Best.-Nr.: 14 54 75-33 Typ A 9060 Seite 995
Hi!
So I think I´ll have to place my next Conrad order soon :)
Btw, feel free to visit my page, it contains some information on DIY for german speaking builder.
Greetings,
Klaus
Hallo Klaus,
hab eben schon mal auf deiner Site vorbeigeschaut.
Ciao
jan