Print Page - Tonepad's BMP pcb question

Title: Tonepad's BMP pcb question
Post by: PB Wilson on April 27, 2004, 04:01:42 PM

I'm planning on building a variation on the Big Muff Pi and due to the number of parts, I'm not too keen on building it on perfboard. :shock:

I was looking at different pcb layouts on the web and had a question about Tonepad's layout. There appear to be two +9v pads on the pcb. Does it matter which one I use?

Title: Look at the schematic
Post by: petemoore on April 27, 2004, 05:26:18 PM

And compare. with PCB..Get the DMM on beep mode, Black to the 9V+ Pad, where battery connects, and see if you get continuity to all points on the board that call for it for 9V+.

Title: Tonepad's BMP pcb question
Post by: Gringo on April 27, 2004, 05:42:57 PM

It doesn't matter which one you use, just go with the one that better suits your box layout.

Title: Tonepad's BMP pcb question
Post by: PB Wilson on April 27, 2004, 07:36:17 PM

Thanks guys.

DIYstompboxes.com

DIY Stompboxes => Building your own stompbox => Topic started by: PB Wilson on April 27, 2004, 04:01:42 PM