Text only | Text with Images

DIYstompboxes.com

DIY Stompboxes => Building your own stompbox => Topic started by: Shawk on June 10, 2004, 01:11:47 AM

Title: How to wire a DPDT switch for parallel loop operation.
Post by: Shawk on June 10, 2004, 01:11:47 AM
Can this be done?

I already have it wired for series like this:


  Send  |  | Receive

     In   |  | Out

Bridge   |_|    (these two soldered together)


How do I wire this for parallel effect operation?


Thanks
Title: How to wire a DPDT switch for parallel loop operation.
Post by: R.G. on June 10, 2004, 12:16:27 PM
Quote
I already have it wired for series like this:

Send | | Receive
In | | Out
Bridge |_| (these two soldered together)
You're there. That will work.

QuoteHow do I wire this for parallel effect operation?
You can't easily do that without some kind of mixing resistors at least.
Title: How to wire a DPDT switch for parallel loop operation.
Post by: Shawk on June 10, 2004, 06:00:43 PM
If this helps, I want a clean signal going to the amp with the effected signal going to the same amp too. Kind of like clean + dirty, or clean + tremolo etc..


How is this done?
Text only | Text with Images