Text only | Text with Images

DIYstompboxes.com

DIY Stompboxes => Building your own stompbox => Topic started by: bazzwazzle on August 27, 2004, 02:39:09 AM

Title: aron what is the mounting hole diameter for your 3PDT switch
Post by: bazzwazzle on August 27, 2004, 02:39:09 AM
thanks in advance.
Title: aron what is the mounting hole diameter for your 3PDT switch
Post by: mikeb on August 27, 2004, 04:13:25 AM
12mm or 1/2"

Mike
Title: .
Post by: petemoore on August 27, 2004, 10:43:44 AM
yupp 1/2...I was drillin' yesterday for one.
Title: aron what is the mounting hole diameter for your 3PDT switch
Post by: bazzwazzle on August 27, 2004, 12:10:51 PM
1/2" diameter? ok thanks.
Title: aron what is the mounting hole diameter for your 3PDT switch
Post by: aron on August 27, 2004, 01:38:40 PM
Thanks guys! Yeah, I use that unibit for everything so I don't even measure or anything. Just keep drilling till it fits.
Title: aron what is the mounting hole diameter for your 3PDT switch
Post by: Fret Wire on August 27, 2004, 01:56:58 PM
3PDT shaft dia. = .460-.463
             15/32 = .469
            12mm = .472
                1/2 = .500

I usually use 15/32, nice and tight. 12mm is just about perfect. Nice and tight, and there's room for bit wear. 1/2 will never miss.

The Unibit solves all the math.
Title: aron what is the mounting hole diameter for your 3PDT switch
Post by: bazzwazzle on August 27, 2004, 11:25:15 PM
eh, i don't have a unibit and short on money. :( you lucky people with jobs. I need a job. i'm too young :'(
Text only | Text with Images