Print Page - Milenium II Bypass LED problem

Title: Milenium II Bypass LED problem
Post by: Ricardo Antunes on September 23, 2004, 04:59:27 PM

Hy friends!!!
WhatÂ´s happening here with my bypass LED? When the effect is off, after some minutes the LED turn on again (just a little less bright). In my Small Stone, just some seconds after I stomp turning off the effect, the LED begins to pulse (according the LFO pulses rate ?).
I used BST72A MOSFET for substituting the original BS170 (I didnÂ´t found it in Brazil).
Can you help me, please?

Thanks

Title: Milenium II Bypass LED problem
Post by: Thomas P. on September 24, 2004, 07:32:52 AM

Most times a bypass didn't worked I simply burned the Mosfet. It is very(!) sensitive to static electricity, though.

Title: Milenium II Bypass LED problem
Post by: Mike Burgundy on September 24, 2004, 08:48:09 AM

what did you use for the low-leakage diode?
Just thinkin' out loud here...

DIYstompboxes.com

DIY Stompboxes => Building your own stompbox => Topic started by: Ricardo Antunes on September 23, 2004, 04:59:27 PM