DIYstompboxes.com

DIY Stompboxes => Building your own stompbox => Topic started by: arma61 on October 21, 2007, 04:43:45 PM

Title: Millenium is not working on this circuit, what's missing ?
Post by: arma61 on October 21, 2007, 04:43:45 PM
Hi

I've build this Minisynth, it's working almost good, but cannot connect a Millenium bypass circuit to it, the MB dosn't work conencted to this but if I connect the MB to another circuit (DOD OD250 or ousb) it works. I've tried to put a 2.2M resistor from signal in to ground (even a 6.8M) but still not working.

what do you think about?

here the link to the schem.

(http://img147.imageshack.us/img147/8766/minisynth22mn0.th.jpg) (http://img147.imageshack.us/my.php?image=minisynth22mn0.jpg)

thx
Armando
Title: Re: Millenium is not working on this circuit, what's missing ?
Post by: slacker on October 21, 2007, 05:41:01 PM
Where did you put the resistor? If you put a 100k resistor from after the output cap to ground it should work, on the schematic that would be from J1 1 to ground.
Title: Re: Millenium is not working on this circuit, what's missing ?
Post by: arma61 on October 22, 2007, 06:28:02 AM
Thx Slacker, you cleared my mind!, I cannot check it now but I think I connected the resistor to the input cap instead of the output cup!, this project born upside down! I'll try tonight with the 100k resistor
Title: Re: Millenium is not working on this circuit, what's missing ?
Post by: arma61 on October 22, 2007, 03:25:52 PM
Slaker you saved me!, it works and I've found, as I said before, I've overlooked at the pcb and put the resistor to the input cap. Now I can finish my multifxboard (just 4 fx!) .I  was just missing this last LED.