Print Page - B100K Push/Pull Pots

Title: B100K Push/Pull Pots
Post by: fogwolf on September 30, 2008, 02:43:59 PM

Anyone know where I could find a B100K Push/Pull switch pot in the U.S. (with solder lugs)? Haven't been able to find any for that value and taper.

Title: Re: B100K Push/Pull Pots
Post by: John Lyons on September 30, 2008, 03:48:15 PM

I have some of these, 24mm 100K-B with a SPST switch at full CCW.

john

Title: Re: B100K Push/Pull Pots
Post by: fogwolf on September 30, 2008, 04:17:04 PM

Maybe I'm confused - I have found what I think you're describing (the switch is activated by turning knob to & from all the way ccw, right?). I'm looking for a pot with this value and taper where the switch is controlled by pulling the shaft out and pushing it in, this way you can activate/deactivate the switch at any resistance level/knob radius.

Title: Re: B100K Push/Pull Pots
Post by: kurtlives on September 30, 2008, 04:19:02 PM

http://www.smallbearelec.com/Detail.bok?no=619

Title: Re: B100K Push/Pull Pots
Post by: fogwolf on September 30, 2008, 04:25:22 PM

Thanks. I had seen these and might resort to them but was hoping I could find one with solder lugs rather than PCB mount.

Title: Re: B100K Push/Pull Pots
Post by: doug deeper on September 30, 2008, 05:51:25 PM

hey john,
where would i find some of these pots you speak of?

Title: Re: B100K Push/Pull Pots
Post by: kurtlives on September 30, 2008, 09:02:43 PM

Quote from: fogwolf on September 30, 2008, 04:25:22 PM
Thanks. I had seen these and might resort to them but was hoping I could find one with solder lugs rather than PCB mount.

Its super easy to wrap a wire around the lug and solder.

Title: Re: B100K Push/Pull Pots
Post by: fogwolf on October 01, 2008, 10:26:13 AM

I think I found them - http://www.mouser.com/Search/Refine.aspx?Ntt=313-1601f-

DIYstompboxes.com

DIY Stompboxes => Building your own stompbox => Topic started by: fogwolf on September 30, 2008, 02:43:59 PM