Print Page - Looking for solder pins & female part

Title: Looking for solder pins & female part < 1.0 mm in diameter
Post by: peterv999 on April 08, 2010, 08:24:09 AM

I'm wondering if someone could provide a pointer to solderpins including the female part with a diameter of < 1mm. Thanks!

-Piet

Title: Re: Looking for solder pins & female part < 1.0 mm in diameter
Post by: maarten on April 09, 2010, 07:35:34 AM

Piet, wat bedoel je eigenlijk....?
Maarten

Title: Re: Looking for solder pins & female part < 1.0 mm in diameter
Post by: peterv999 on April 09, 2010, 09:25:22 AM

Quote from: maarten on April 09, 2010, 07:35:34 AM
Piet, wat bedoel je eigenlijk....?
Maarten

Maarten,
In most cases the plated through hole is 1mm to accomodate for a 1mm round "shaft" form type of solderpin. The area below the rim is to be inserted into that hole while the top part is the interface to a female part (your wire connector). The 1mm assumes it's a press-fit mount. When applied to a plated-through-hole specified for 1mm this is too small hence press-fit will damage the hole .

Kind Regards (groetjes)

Piet

Title: Re: Looking for solder pins & female part < 1.0 mm in diameter
Post by: ~arph on April 09, 2010, 09:53:53 AM

These perhaps:

http://www.sparkfun.com/commerce/product_info.php?products_id=743

I need some too so perhaps we can share an order. ( I'm the same ~arph as on newtone-online )

DIYstompboxes.com

DIY Stompboxes => Building your own stompbox => Topic started by: peterv999 on April 08, 2010, 08:24:09 AM