has anyone done a led lfo rate mod to this circuit?
http://lectric-fx.com/product/bloodstone-phase-shifter-v-1-1/
http://lectric-fx.com/wp-content/uploads/2016/07/Bloodstone_V.1.1.pdf
Try a diffused LED from pin 8 of the 324 with a 4k7 to ground, if that works but doesn't turn 'off' enough, add another 4k7 in parallel with the LED.
If it works but messes up the sweep you'll need a transistor buffer.
cheers , i was playing around with the 324 legs but couldnt get any throbbing, i will give you suggestion a go!
thanks
no good, i couldnt even get any voltage variation at all from pin 8, bummer, none of the other pins or rate pot legs etc had any voltage lfo changes i could find
No moving voltages at all? This might seem like a silly question but, you weren't in manual mode by mistake were you?
i thought that too, but will double check again!
got it working! yes you were right i didnt work on either setting, i was using the wrong resistance range, it turned out that 82 ohm resistor gave me they best throb.
thanjkyou!!
i just connected the resistor to the leg of the transistor which connects to the pin of 324 you suggested,, thanks again!!!