I love the bosstone!! I started with the Nashville schematic. I changed the in/out to .1uf. I added a 47uf and a reverse polarity diode across the power rails. I ended up with a 30K resistor across the 100k voltage sag pot in series with a 2k to limit it to about 25k which is what I measured as my sweet spot for trumpeting.
For whatever reason, the YouTube tag (or my browser?) now wants "https://"
Thanks! I updated the original post... My home browser was fine but I realize now that my phone browser wants htrps
Now you are ready to belt out those tunes.
I'll get my coat...
Seen the KMA 'Fuzzly Bear'?
Quote from: rutabaga bob on April 01, 2019, 01:32:04 PM
Seen the KMA 'Fuzzly Bear'?
Just looked it up... awesome sounding bosstone! I'm amused at what each builder decides to call the voltage control... KMA went with skin/meat lol
Wonderful job, Chris!
Did you use 1N4001 for clipping?
And did you connect the sag 1 pin with 30k and 2k? I did't understand very well, could you make a little schem, please?
thanks so much and congratulation again for your leather sound pedal!!! :icon_lol: :icon_biggrin: