built form here http://tagboardeffects.blogspot.com/2013/12/ehx-ic-big-muff-v5-78.html
I used a tl071 for ic2 replaced the 820k with 1m as listed
when I engage the pedal the volume is low. you have to turn the volume up to 7 to get the same volume as when off. all resistors are carbon film 5%. last pedal useing them going to metal film 1%.
voltages are at 9 volt
4558
1 4.22
2 4.23
3 4.18
4 0
5 4.2
6 4.2
7 4.2
8 8.49
TL071
1 0.14
2 4.2
3 4.0
4 0
5 0.14
6 4.2
7 8.49
8 0
(https://i.postimg.cc/JHLm7JZj/WIN-20200901-07-25-44-Pro.jpg) (https://postimg.cc/JHLm7JZj)
(https://i.postimg.cc/9R3H1Txs/WIN-20200901-07-25-07-Pro.jpg) (https://postimg.cc/9R3H1Txs)
Is there any volume difference between Tone ON & BYPASS..??
yes
It shouldn't be.. :icon_wink:
There should be a resistor of about 150k in series with signal when Tonestack bypassed..
ok rebuilt board with all metal film 1% resistors. no volume change with the tone bypass switch. but the low volume still remains. any more ideas
Thanks
the schematic used was from Analogguru's schematic
you could try an audio probe at pin 6 (output) of ic2 audio probe is just a guitar cable with one side to amp and the other sides ground lead connected to circuit ground (alligator clip or soldered) and the hot lead connected to one side of aa cap and the other side to different 'test' points. basically see at what point in the circuit the level becomes low, then you can check that area to figure out why the signal is dropping...
looking at the schematic you could also just desolder vol3 wire (vol1 is ground it appears) and use that as a 'probe' that wire is goint to the out jack so if you touch it to ic2 pin6 it should tell you if the vol drop is happening at the tone control section...
ok so it is in the tone control section. pin 6 has good volume
ok got good signal to vol lug 3. it calls for a log 100k . to get the same volume when pedal is disengaged vol has to be at 10
it just seem right but maybe it is
At ten o'clock it's more than fine.. :icon_wink:
Volume level depends on last stage output impedance & Vol pot (setting & value) & next stage input impedance..
done with this one