so i came across a thread about clipping and had the concept of 'dynamic crossover' i wasn't sure what was meant, but this is what i came up with.
(https://i.postimg.cc/GTpGMRGf/dynamic-crossover-distortion.png) (https://postimg.cc/GTpGMRGf)
it takes out the middle section of a wave independent of amplitude. crossover distortion without gating. does anyone think there is a use for this???
i won't be able to test this before tuesday so if anyone has a leftover breadboard and enough interest, please go ahead.
cheers, Iain
Will it sound like a cold biased EL84? Maybe a bit like a 18watt?
i think it would sound different than a cold bias valve, since it messes with both wave halves independent of amplitude. where the cold bias is more noticeable with lower volumes, this is independent of volume and the knee is waaaaaaaayyyyy harder
Independent of volume? Than it is not dynamic, right?
Quote from: Steben on October 26, 2020, 02:01:27 AM
Independent of volume? Than it is not dynamic, right?
its dynamic in the sense that its not a constant voltage that is crossover distortion-ed out, it is a set portion of the input voltage. the simulations give the same waveshape at 50mV or 5V. so the crossover threshold is dynamic... i guess... im not really shure, idk if you have seen my response in the 'members only area' thread about clipping?
cheers, Iain
Example of dyn X-over and drive with a rising sine input
(https://i.postimg.cc/HcDFJFRR/sag-control.jpg) (https://postimg.cc/HcDFJFRR)
Since a portion gets "eaten" the RMS value does not go up linearly. It can go from compression to even decline depending on the settings. In extreme settings you get that dumped swirling "Squish" sound with the signal coming back clean.
what kind of schematic would create such an effect? that is really cool! does it have to do with the bias changing along with the input amplitude?
cheers, Iain
edit: no need to answer, you already did in the other thread