Greetings - I'm embarking on the "construction" of a Love Clone Brown Source and need a little help. For the life of me I cannot tell how to wire the pots correctly. Lug 2 is obvious - I really want to get this right the first time - and not have to resolder. Could someone please tell me which pads are for Lug 1?
My pots are facing with the solder tabs down - lug one is on the left.
Scematic and PCB layout at:
http://www.esnips.com/doc/94528c01-c4d1-47a0-a093-8740996b081c/Loveclone-Brown-source.pdf
Thanks in advance.
I got it - feel free to delete this topic!
Quote from: scotsman on September 10, 2006, 01:43:46 AM
I got it - feel free to delete this topic!
I got it "fired up" very late last night - wasn't able to give it a proper blessing until a bit ago. It has a strange buzzyness to it - almost gated. I've gone through the board all the components are in their right place. I did notice if I touch the solder pads with my finger on the side of the op amp near the 22k resistor it seems to "clean up." Possible cold joint or what?
Oh - I'm using a 4558 in this.
Any help is greatly appreciated.