hi,
i've done a vero layout for the tremulus lune, which is based on the one made by torchy but is adapted for the last Rev.2.4.1. that you can find on commonsound (this: http://commonsound.org/tremulus/pcb2.4.1/schematic.pdf ).
N.B.: i didn't draw the LFO Led and the two 1k resistors that goes together with it (R12 & R16), since this is a feature i don't care about. is it right to leave them away like that or do i need a 2k resistor that goes from pin 1/2 of the 4558 to ground?
N.B.2: It would be nice if some one can check it out for errors.
here you go:
(http://i19.tinypic.com/4vg5q8m.gif)
ENJOY :icon_mrgreen: :icon_mrgreen: :icon_mrgreen:
pay attention, i made some little changes, here it's the new one:
(http://i11.tinypic.com/66xlauo.gif)
Nice, I like the way the LFO and audio section are separated. I think I might check it out tonight.
Thanks!
Hi, has anyone tried this one out?
Good effort by the way, I was tempted to get the pcb for this as I liked the phaseur fleur a lot, but might try this vero layout instead.
Looking at the schem, it would be quite easy to add the symmetry pot wouldn't it?
hi, the simmytry is simply a pot wired around the speed pot, so you don't need extra components on the pcb.
i' haven't cheecked it yet, but there's also this vero layout (on which i based mine) which works for shure
http://i197.photobucket.com/albums/aa131/veroboard/Tremulus_Vero.gif (http://i197.photobucket.com/albums/aa131/veroboard/Tremulus_Vero.gif)
the schem for this layout is this one:
http://i12.tinypic.com/4qeduzc.jpg (http://i12.tinypic.com/4qeduzc.jpg)
Ok cheers, I hadn't seen that one before
Quote from: Gila_Crisis on August 13, 2007, 01:47:42 PM
hi, the simmytry is simply a pot wired around the speed pot, so you don't need extra components on the pcb.
i' haven't cheecked it yet, but there's also this vero layout (on which i based mine) which works for shure
http://i197.photobucket.com/albums/aa131/veroboard/Tremulus_Vero.gif (http://i197.photobucket.com/albums/aa131/veroboard/Tremulus_Vero.gif)
the schem for this layout is this one:
http://i12.tinypic.com/4qeduzc.jpg (http://i12.tinypic.com/4qeduzc.jpg)
Cool!
Is there one with the symmetry on it as well? I have been looking for one with a PCB layout, I can't find the image to make a pcb
Has this been verified?
Does anyone have a copy of Torchy's Lune layout?
http://www.indyguitarist.com/torchy/Tremolo/Tremulus%20Lune/ (http://www.indyguitarist.com/torchy/Tremolo/Tremulus%20Lune/)
A layout with no values or labelling! Thanks but I already found that, kinda useless.
Yeah, you would have to kinda use the schem at tonepad.com to figure it out..
hi, the layout above is verified. actually is based on torchy's layout, i just changed some values to match the last revision of the schem found on http://www.commonsound.com/ this one: http://commonsound.org/tremulus/pcb2.4.1/schematic.pdf