hi folks-
i have two EV S200 pa speakers and an old peavey XR600 powered mixer which works good for my small gigs.
my question is thet i have the chance of buying the EV S200 system controller device which apparently gives some extra freq response and headroom.
i checked the web and found this manual http://archives.telex.com/archives/EV/Miscellaneous%20Electronics/Owners%20Manuals/System%20Xp200%20Owners%20Manual.pdf
which appears to suggest that hookup has to be done at line level with a separate mixer and power amp......
can anyone advise if i could use this system with my existing peavey powered mixer?
the peavey has 1/4 inch jacks for power amp in / aux in / graphic in / graphic out /
outputs for mon / main / efx and
two each of phonos for tape in and tape out [ maybe these could be used with an adaptor cable quarter inch to phono? ]
thanks guys
bob
does the mixer have inserts on the master?
hey ,
it doesnt have inserts ..
its an old school mixer amp head thingy like this http://www.bing.com/images/search?q=peavey+xr600c&FORM=BIFD with 6 channels
cheers
b
http://www.yoreparo.com/foros/files/peavey_xr_600c.gif (http://www.yoreparo.com/foros/files/peavey_xr_600c.gif)
main out - controller - power amp in
or
graphic eq out - controller - power amp in
thank you sir !
im going to look at it tomorrow will try this suggestion :)
wait! don't use main out! use graphic out if not used for monitors. check controller manual (online pdf?) for input specs. graphic out looks safer.
http://www.peavey.com/assets/literature/manuals/80370039.pdf (http://www.peavey.com/assets/literature/manuals/80370039.pdf)
cool matey , willdo...
;)