MXR Envolope Filter - Weak output?

Started by dude, May 31, 2004, 09:57:29 PM

Previous topic - Next topic

dude

Anybody have any fixes for the attenuation/loading this pedal does to a signal?  Thanks in advance ~MJH

Gringo

I attached a lpb at the end of mine to get it at unity gain (or at whatever volume you weant it to be).
Cut it large, and smash it into place with a hammer.
http://gringo.webhop.net

sir_modulus

For good LPB schematics go to www.tonepad.com (has layout and mods(i think)), or FuzzCentral.

StephenGiles

I never had any drop in volume when I messed around with this. You must have a wrong part in there somewhere. I was using a 4049 I remember because you can't buy 4069s on a Saturday evening in these parts!
"I want my meat burned, like St Joan. Bring me pickles and vicious mustards to pierce the tongue like Cardigan's Lancers.".

Mark Hammer

Those who have built the Tonepad layout have posted several useful suggestions for altering bandwidth, sweep and output level.  Check the builders' comments there.

dude

This isn't a new build but an actual MXR unit.  I realize the LPB is a small circuit but will it fit into an existing MXR EF?  I'd assume if it could it would share the 9v power supply?  or does this need to happen in another box?  thanks ~MJH