Author Topic: WTB: Beavis Prototyping Jig  (Read 6805 times)

aegert

  • member
  • *
  • Posts: 1
WTB: Beavis Prototyping Jig
« on: January 08, 2014, 02:24:29 PM »
hey anyomne have a Beavis Prototyping Jig fro sale or any other for that matter? please pm or better email me aegert AT motb DOT org

thanks!

a

Havaden

  • member2
  • *
  • Posts: 55
    • Personal Homepage
Re: WTB: Beavis Prototyping Jig
« Reply #1 on: November 04, 2015, 03:41:24 PM »
I don't have one, but they are pretty easy to make.
Just buy some plywood and glue a breadboard on there together with a small metal/plastic/acrylic panel with potentiometers and switches.
Its not really harder than making a pedal.
It's not always easy, but it's never impossible :D

Gibson SG Special worn brown 2006 (W. Bigsby b3)
Squier bullet fiesta red 2009 with a ton of care and mods.
Chibson LP Custom 2015 (Fixed broken neck)
Gibson LP Junior 2009

loss1234

  • member2
  • *
  • Posts: 261
Re: WTB: Beavis Prototyping Jig
« Reply #2 on: March 02, 2019, 01:31:47 PM »
Casper electronics makes something very similar but with 1/8” jacks
It includes power , an output power amp , pots and a “vactrol “

I think it’s called the OHM synth

bamslam69

  • member2
  • *
  • Posts: 291
  • Pete
Re: WTB: Beavis Prototyping Jig
« Reply #3 on: March 05, 2019, 07:49:46 PM »
As per Havaden's response.
I just have a bit of wood, some breadboard glued on it, and a couple of rows of terminal strip.
It's not the best, maybe I could streamline it by attaching some sheet metal that I can screw the pots, switches and jacks to, but it does the job for now. 
Rhythym in jump, dancing close to you