Author Topic: Building a Paul C TIM  (Read 1037 times)

thecakeguru

Building a Paul C TIM
« on: April 27, 2016, 02:57:14 PM »
Hey. New to pedal building. Built a signa drive. Now Im building a Paul C Tim from tagboardeffects. Question, I got it finished minus the boost switch and diode switch. All works, but the treble pot still filters off my highs in the full on position, and sounds very muffled if I start to turn it down, not at all how it should work. Any Ideas?

george

Re: Building a Paul C TIM
« Reply #1 on: May 10, 2016, 10:33:40 PM »
schematic?

nocentelli

Re: Building a Paul C TIM
« Reply #2 on: May 11, 2016, 12:49:23 AM »
Check the tone cap is definitely 10n not 100n
Quote from: kaycee
squeeze on the back and never open it up again

Ben Lyman

Re: Building a Paul C TIM
« Reply #3 on: May 11, 2016, 03:03:48 AM »
Here's the link. This should help the helpers  ;)

http://1.bp.blogspot.com/-pr7Up07eVs4/UtauuzsDYrI/AAAAAAAAF7U/8nbvCtK3OA4/s1600/Paul+Cochrane+Tim.png

Also, some pics of your build to accompany this link might speed things along.
Good luck!  :)
"I like distortion and I like delay. There... I said it!"
                                                                          -S. Vai