AMZ FX ANALOG ALCHEMY GEOFX MEF ROG DIY WIKI

News:

SMF for DIYStompboxes.com!

Main Menu

Easy Face

Started by jimbob, October 18, 2003, 05:05:49 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

jimbob

October 18, 2003, 05:05:49 PM
Building an Easy Face. I do not have the req. .01 uf for c2. Its supposed to be an electrolytic cap. Any thing else i can use?
"I think somebody should come up with a way to breed a very large shrimp. That way, you could ride him, then after you camped at night, you could eat him. How about it, science?"

petemoore

#1
October 18, 2003, 07:29:35 PM
...and around inputs [like that] I always just use a socket.
 Since your request has been here a while...Ill take a shot...
 If I remem the master saying bipolar caps are just that...two polarized caps back to back, one inverted blast me for saying so if Im wrong...
  Anyway it should block DC so you can try anything around 4.7uf or less.
 also I think one of these caps could be eliminated by using a single incap without the pot or adjusting the pot so it goes only through the one cap and leave the other out till ya get it.
 1 cap I think could be spliced in where the two caps and a pot are
Convention creates following, following creates convention.
Print
Go Up Pages1
User actions