Uh Oh, I need help!!!

[Hooch]

Okay I'm about half way through poulating my board.
I'm doing this one http://www.generalguitargadgets.com/v2/diagrams/ts_lo_808.gif

Take a look at the C5 capacitor. It shows it is non polar.  But when I looked at the cap I have It has the info on one arm and a ++-- on the other.  This is the one I ordered.
  http://www.vishay.com/docs/40020/199d.pdf
It is suppossed to be a solid tantalum cap.

My question is can I use this one?  Do I have to be concerned with the direction?  If so which way do I hook this badboy up?

[R.G.]

can I use this one?

Yes.

Do I have to be concerned with the direction?

Yes.

If so which way do I hook this badboy up?

+ marked lead inboard towards the IC, - marked lead toward the edge of the board.

[Hooch]

Thank you R.G. for the quick reply.  If you would help me one more time the same value cap is used for the C9 spot I think it should go + toward the output and - side toward the R11 resistor.  Again thanks so much for your help.

[Peter Snowberg]

...the same value cap is used for the C9 spot I think it should go + toward the output and - side toward the R11 resistor.

You are correct.

Take care,
-Peter