Add a Volume pot?

[Kentone]

I've got these true bypass pedals im making, and I was wondering how to go about putting a volume pot inside as well. How would I wire it up to the drawing I went by on Aron's schematic page?

thanks,
Aaron

[aron]

Put the volume pot in between the effect out and the switch. It would be wired like the volume pot on this schematic:



The volume pot right at the end of the circuit. You can start with a 100K pot and raise the value if necessary.

effect out tip of jack goes to outer lug, wiper (middle) goes to switch lug, the other outer lug of the pot goes to ground.

Aron

[Kentone]

Ok, awesome! Thanks abunch Aron!