AMZ FX ANALOG ALCHEMY GEOFX MEF ROG DIY WIKI

Vintage MXR Flanger

Started by JasonG, June 29, 2005, 04:05:04 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

JasonG

June 29, 2005, 04:05:04 PM
I have just gotten a vintage mxr flanger. But it needs a new cord and the cord that is on it is not original. Does any one know where to get a nos cord for this? If not could some one tell me how long the cord is from the bottom of the plug to the pedal case and what style it is . Also is it a two or three prong cord. the cord on it now has a three prong plug but only two wires are hooked up in the pedal.
Thanks alot!  Jason
Class A booster , Dod 250 , Jfet booster, Optical Tremolo, Little Gem 2,  mosfet boost, Super fuzz , ESP stand alone spring reverb red Llama omni-drive , splitter blender ,

NEVER use gorilla glue for guitar repairs! It's Titebond , Elmers, or Superglue

george

#1
June 29, 2005, 11:21:48 PM
DON'T PLUG THIS PEDAL IN UNTIL YOU VERIFY THAT IT'S OK NOT TO HAVE THE THIRD WIRE HOOKED UP - YOU COULD KILL YOURSELF.

I had one of these and it had a 3 prong plug and Also the earth was connected via a ring connector to the case by one of the screws holding the PCB in place - IN WHICH CASE IT IS NOT DOUBLE-INSULATED - so don't take your life in your hands

rtcook

#2
July 11, 2005, 03:13:27 PM
I have a cord for it somewhere.  Let me look.

Roger
Print
Go Up Pages1
User actions