Author Topic: Basic schem question  (Read 3775 times)

Red2112

Basic schem question
« on: April 29, 2007, 08:50:36 PM »
Greetings,

Aim a bit confused in this issue. In theory, on a electrical schem, a line that crosses another line with a dot in its intersection means both lines are connected, but then I see many schems that dont show a dot in its intersection (even no dots on the whole schem). In theory, when a line dosent connect with another, it should be shown as bridged.

Is not drawing dots in intersections just a fast way of drawing schems, or laziness?

Thank you in advance,


Mike

tcobretti

Re: Basic schem question
« Reply #1 on: April 29, 2007, 08:56:26 PM »
If there are no dots, then lines that cross but do not connect electrically should have a U in the line indicating a lack of connection.

Example:


Red2112

Re: Basic schem question
« Reply #2 on: April 29, 2007, 09:23:49 PM »
Thanks Tcobretti!

That clears up my doubt  :)

Good care