Author Topic: Avr studio or stk500 problem  (Read 3230 times)

zerohero

Avr studio or stk500 problem
« on: June 30, 2007, 01:19:01 AM »
Hey guys, I was going to program an AVR with some code i've been working on and i hadnt used the stk 500 yet, so i updated the firmware and that went fine, when i try to program the avr i keep getting an error that says something liek this:

"A problem occurred when executing the command. See the command output for more information"



then it lists a bunch of quick tips and i checked all those and the troubleshooting guide and everything seems to be fine.
I am using the latest version of all the software, AVR studio and winAVR. the chip itself is an Atmega8535.

i running this on a mac through boot camp but i have never read of this issue before.

 i know this is super vague but i dont have anything else to go off of


any help would be appreciated.

thanks as always

Jose

zerohero

Re: Avr studio or stk500 problem
« Reply #1 on: June 30, 2007, 11:50:17 AM »
nevermind, it works in HV programming. so ill just use that.

Jose

bioroids

Re: Avr studio or stk500 problem
« Reply #2 on: July 03, 2007, 12:44:17 PM »
Check you don't have spyware/malware or other strange stuff in your computer. They can cause some strange issues with AVR Studio 4 (I found that on AVR Freaks forum and experienced it myself!)

Regards

Miguel
Eramos tan pobres!