OK - I just verified two more things;
1) Where the feedback pot lug 2 connects to the board; there's a 20K resistor. Replacing with a 100K resistor tames the feedback pot so that it doesn't oscillate as quick and is much more controllable; this was mentioned early in the thread, but I wanted to bring it up again since it does help the oscillation too early issue I was having.
2) To add the WET effects loop (each repeat is more effected) - take the wire from lug 2 of the feedback pot and it goes to the tip of your SEND, then the tip of your RETURN goes to where lug 2 would have gone on the board.
**This version of the wet loop gives you one normal repeat and then each subsequent repeat is more and more effected. This is NOT the mod where the first repeat is effected.
I added shunting jacks and am using both the dry loop and wet loop for some real insanity. Another delay in the wet loop with a slapback delay almost turns into a reverb sort of effect that kicks in around the third or fourth repeat... I tried a second delay in the dry loop and a third delay in the wet loop and my mind started to turn to mush...
Then I crammed it all back into the box and now I'm only getting one repeat no matter what on my feedback loop so I need to do a little troubleshooting before I do much else.
Starting to think I need a larger enclosure....
Check it out (
CLICK HERE)
I use PCB layouts; so I can't give you a perf layout; but heres the layout that I used showing the mods...
I know there's two different versions of the anonfacecow layout; but this is the one I've used a couple times without any problems, so I keep using it.
Here's the layout with the change to give you send/receive for the dry loop mod; since there's no traces needing cut for the wet loop mod, no layout change is needed for that mod.
