Running FV-1 Fraverb board in mono/

[dustyhills]

To run the Fraverb board in mono do I just use the inR and the outR or do I have to tie the left and rights to gether??? 

[Taylor]

I think Spin recommends tying the inputs together, and letting the unused output float (leave it unconnected).

[dustyhills]

Thanks! I'll give it a try. I'll be gone for a week so I won't report on it till after I get back.

[dustyhills]

You were right! I found this on Spins site:

Posted: Thu May 06, 2010 11:01 am    Post subject:   

--------------------------------------------------------------------------------

Tie the input pins together so the unused input is driven. Let the unused output just float, in code I would write the same value to it as the used output so it was driven internally but not connect anything to the pin.
_________________
Frank Thomson
OCT Distribution