Aria DT5 Distortion?

[Arn C.]

I am repairing an Aria DT5 Distortion.  It had major water damage and one cap exploded all over.   I can read the value of it but not sure of its orientation(electrolytic).
Does anyone have a schematic or picture of the board?

Note:  The board says DT-10 on it and only half of the board is used.

Thanks!
Arn C.

[PRR]

> not sure of its orientation

Power up without cap. Put voltmeter in cap holes. Swap probes until meter shows positive (not negative) voltage. Now the red probe is on cap + pad, black probe is on cap - pad.

(Assuming the colors are plugged into the METER correctly!)