op amp sectioj of schemtic wrong?!?!?!?!?

Started by curran, February 03, 2008, 08:54:54 PM

Previous topic - Next topic

curran

 :-\ I went to build this bad bear off of the schematic only the pins 6 and 7 of the schematic are backwards to the wiring diagram. if you build it off of the schem alone the project does not work. switch these two pins around on the board and VIOLA!!! I am not sure if anyone brought this up before but it was a few minutes of "WHAT THE F--K!" on my part

Love Curran

gaussmarkov

Quote from: curran on February 03, 2008, 08:54:54 PM
:-\ I went to build this bad bear off of the schematic only the pins 6 and 7 of the schematic are backwards to the wiring diagram. if you build it off of the schem alone the project does not work. switch these two pins around on the board and VIOLA!!! I am not sure if anyone brought this up before but it was a few minutes of "WHAT THE F--K!" on my part

hi curran, check again. pins 6 and 7 are correct on the bread board wiring diagram and consistent with the schem.  for example, the schem says that pin 6 hooks up with C4 and C4 hooks up with pin 6 on the wiring diagram via a jumper.

perhaps you are not counting the pin numbers correctly?  pin 1 has the square pad, lower left-hand corner.  pin 4 is in the lower right-hand corner.  pin 5 is immediately above pin 4, on the upper right-hand corner.  if you mistakenly count pin 5 in the upper left-hand corner then you could get pins 6 and 7 reversed.

all the best, paul

curran

I was counting the pins wrong thanks for the help!!!!!!  :icon_eek:woo hoo!! are all IC's counted this way?!?!!??! :icon_smile:

gaussmarkov

Quote from: curran on February 04, 2008, 12:16:06 AM
I was counting the pins wrong thanks for the help!!!!!!  :icon_eek:woo hoo!! are all IC's counted this way?!?!!??! :icon_smile:

yah shure!  you betcha! :icon_wink: